They are suitable for the transfer of liquids containing impurities up to 3 mm in size. The hydraulic components: impeller, scroll and pump body in PBT, allow it to be used with water, emulsions and oily substances in general, with a viscosity not exceeding 21 cSt (3 ° Engel). The liquid temperature must not exceed 70 ° C.
They are commonly used on:
- machine tools (cutters-lathes-drills)
- glass processing machines (TRI version)
- printing machines
They should normally be installed on a tank with a capacity proportionate to the flow rate, about 3-4 cm from the bottom. It is important to check that the maximum level of the liquid in the tank always remains 3-4 cm lower than the support flange (see figure). In cases where the liquid is particularly dirty, it is recommended to build the tank with compartments, to allow the deposit of sludge before it is fished out by the pump.
Dimension sheet includes SPV Pump weights (lbs) for each suction height.
|PART NUMBER / FRAME SIZE||HP||Full Load Amps - 460V||Full Load Amps - 575V||Suction Height (B dimension in mm)|